10
Hilti accepts no liability for damage or failure caused by:
- Storage and transport not in accordance with the specified conditions.
- Failure to observe the instructions for use and setting data.
- Inadequate design of the anchor points (number of anchors, loadbearing capacity / dimensions).
- Inadequate loadbearing capacity of the base material.
- Incorrect use.
-
Other influences of which Hilti is not aware or on which Hilti has no influence, e.g. use with
products from a third party.
Partly used foil packs
must be used up within
one week
. Leave the mixer attached to the foil pack manifold in the
dispenser and do not retract the pistons! Remove the air pressure hose and store under the recommended storage
conditions. If reused, attach a new mixer and discard the initial quantity of anchor adhesive as described by point 8.
12
Preparation work may continue for rebar applications.
Between
“t cure,ini”
and
“t cure,full”
the adhesive
has a limited load bearing capacity, do not apply a torque or load on the fastening element during this time.
13
Apply load/torque after ” t cure,full”
has passed, and the fixture to be attached has been positioned.
Printed: 30.07.2015 | Doc-Nr: PUB / 5241340 / 000 / 00
