European technical approval
ETA-09/0295
English translation prepared by DIBt
Page 10 of 32 | 9 May 2013
Z38892.13
8.06.01-155/13
5
Recommendations concerning packaging, transport and storage
5.1
Responsibility of the manufacturer
It is in the responsibility of the manufacturer to ensure that the information on the specific
conditions according to sections
1 and 2 including Annexes referred to as well as section
4 is
given to those who are concerned. This information may be made by reproduction of the
respective parts of the European technical approval. In addition all installation data shall be
shown clearly on the package and/or on an enclosed instruction sheet, preferably using
illustration(s).
The minimum data required are:
-
drill bit diameter,
-
diameter of rebar,
-
admissible service temperature range,
-
curing time of the injection mortar,
-
Installation instructions including cleaning of the drill hole,
-
reference to any special installation equipment needed,
-
identification of the manufacturing batch,
All data shall be presented in a clear and explicit form.
5.2
Packaging, transport and storage
The mortar foil packs shall be protected against sun radiation and shall be stored according to
the manufacture's installation instructions in dry condition at temperatures of at least +5
°C to
not more than +25 °C.
Mortar foil packs with expired shelf life must no longer be used.
Uwe Bender
beglaubigt:
Head of Department
Lange
